#ifndef WIRECELL_WIREPARAMS
#define WIRECELL_WIREPARAMS

#include "WireCellIface/IConfigurable.h"
#include "WireCellIface/IWireParameters.h"
#include "WireCellUtil/Units.h"

namespace WireCell {

    /** Embody parameters describing a triple of wire planes and
     * provide a configurable interface. */
    class WireParams : 
	public IWireParameters,
	public IConfigurable
    {
    public:

	/// Directly set the fundamental parameters.
	/// See WireCell::IWireParameters.
	void set(const Ray& bounds,
		 const Ray& U, const Ray& V, const Ray& W);


	/** Set the wire parameters simply.
	 *
	 * This method gives a simpler, more restricted interface to
	 * setting the wire parameter.  It follows the same
	 * conventions as the one above but assumes:
	 *
	 * - The bounding box is centered on the origin.
	 *
	 * - One wire of each plane intersects the X-axis.
	 *
	 * - The magnitudes of the U and V angles are equal.
	 *
	 * - The pitches of all three planes are the same.
	 *
	 * - The X values W, V and U planes evening distributed on the
	 * positive half of the X covered by the bounding box.
	 *
	 * \param dx, dy, dz are the full widths of the bounding box
	 * in the associated direction.
	 *
	 * \param pitch is the perpendicular distance between two
	 * adjacent wires in a plane.
	 *
	 * \param angle is the absolute angular distance from the U
	 * and V wires and the Y-axis.
	 */
	void set(double dx=10*units::mm,
		 double dy=1*units::meter,
		 double dz=1*units::meter,
		 double pitch = 10*units::mm,
		 double angle = 60.0*units::degree);

	/** Provide access to the rays which were used to define the wires. */
	const Ray& bounds() const;
	const Ray& pitchU() const;
	const Ray& pitchV() const;
	const Ray& pitchW() const;
	
	/** Configurable interface.
	 */
	virtual void configure(const WireCell::Configuration& config);
	virtual WireCell::Configuration default_configuration() const;

	WireParams();
	virtual ~WireParams();

    private:
	Ray m_bounds, m_pitchU, m_pitchV, m_pitchW;
    };
}

#endif
