How to configure streams:

One might also want to define its own stream configuration if the above described three default configurations are not suitable. The window for this task can be obtained by pressing the ``change configuration'' button on the dp0 menu window and is shown in figure 9.

 
Figure 9:   dp0 change configuration window.

• Add stream:
  Pressing add stream leads to a configuration window where the streams are defined. Note that you have to define three things, namely the stream name, output device and the triggers.
• Delete stream:
  Deletes the selected stream (remember streams are selected by clicking on them).
• Delete all streams:
  Completely clears the defined stream table
• Save configuration
  Saves the present configuration on a disk file (a motif file selection window comes up on pressing this button).
• Read configuration
  Reads the configuration from a disk file, previously saved using the save configuration option.
• enable/disable streams
  enables/disables the selected stream (selected by clicking on it). See below for further details on disabling streams.