Large Seminar Room

From BNL Physics Computing

Contents 1 Layout 2 Controls 2.1 Light Switches 2.2 Lights/Screen Panel 2.3 Phone/Network Jack 2.4 Projector Remote

Layout

"L" indicates the location of light switches just inside each door "L/S" indicates the location of the two lights/screen control panels "P/N" indicates the location of the telephone and network jacks on the riser of the stairs of the stage

Controls

Light Switches

Light switch inside right hand door

"H" turns the main house lights on or off "L" turns the left aisle lights on or off "R" turns the right aisle lights on or off

Light switch inside left hand door

"L" turns the left aisle lights on or off "R" turns the right aisle lights on or off "H" turns the main house lights on or off

Lights/Screen Panel

Lights and screen control panel at rear of auditorium

Buttons control the screen "Up" starts the screen moving up "St" stops the screen's motion "Dn" starts the screen moving down "D" dims the house lights if held down and raises the house lights if held up "H" turns the main house lights on or off "B" turns the lights over the blackboard on or off "S" turns the stage spotlights on or off "L" controls the lectern light (if it was connected)

Lights and screen control panel at front of auditorium

"S" turns the stage spotlights on or off "B" turns the lights over the blackboard on or off "H" turns the main house lights on or off "D" dims the house lights if held down and raises the house lights if held up Buttons control the screen "Up" starts the screen moving up "Stop" stops the screen's motion "Down" starts the screen moving down

Phone/Network Jack

Telephone and network jack plate on stair riser of stage

The jack above the purple network jack is for the Polycom analog speaker phone (contact Sal Marino, x2281, for the phone) The Jack below the red network jack is for a ROLM digital phone

Projector Remote

Use the "ON-OFF" button on the remote to turn the projector on and off. The remote can be aimed either at the projector or at the screen. When you turn the projector off, you will get a request to confirm the operation. Press the "ON-OFF" button again to confirm.